Pi 4 Bokoblin Skull Case

Get your Bokoblin Skull Chest here! In PI 4 Case Form!
Pi 3 Version is Here - https://www.thingiverse.com/thing:3810846
Reptile fan for tray here - https://www.thingiverse.com/thing:3811141

This will print on a 120 x 120mm bed, Used a Monoprice mini v2 and
a creality Ender 3 to test tolerances.

No Screws needed for Pi itself, Only the fan.
To place Pi in the tray Remove SD Card first, place the HDMI side in and snap the GPIO side down.
For removal take out SD Card and flex the wall at GPIO side and pushing Pi up through thumbhole.

The Jaw will need supports for everything but the hinges.

Skull does not need support at the top so block that off to shave print time. Added Storage slots for 3 SD Cards.

Fan plate will snap into jaw

Use a piece of filament to unite the Hinges.

Horns are Universal Left / Right. There are 2 to choose from.

Eyes will snap in but i Glued them as well. There is Jeweled eye and flat to choose from.
The eyes look wicked if you use 3 or 4 layers and choose Concentric infill. Ironing should
be concentric if chosen.

With cheapo 5v fan from amazon my pi 4 Stays around 44c no matter what i throw at it