CR-10 X-axis Belt Straigtener - Motor Side

Back story:

I printed Cornely_Cool's belt tensioner set for my CR-10.
https://www.thingiverse.com/Cornely_Cool/designs
It also Straightens the x axis belt so it travels freely without dragging on the aluminium extrusion of the x gantry.

https://www.thingiverse.com/thing:3288949
But it was designed for a older model of the printer that did not have the little cover that holds the limit switch.

So i recreated the OEM cover and then merged it with Cornely_Cool's model.
And a lot more has been done to the model to improve it.

---

Hardware needed:

1 x 16 tooth pulley
https://bit.ly/2MnSb86

1 x M3 x 18mm bolt

1 x M3 Nut

The rest of the hardware comes with the printer.

---

About this thing:

It is split into three slices so it can be printed with minimum support.
Not sure if other slicers can place custom supports nowadays, but in Simplify3D i had to place supports in manually because the auto supports did nothing.

So look for the screw hole on Pt. 1 & 2,
And there is also a substantial overhang on Pt 1.
Put the support structures in these 3 spots.

---

Recommended Settings:

All:
0.1000mm Layer height

Pt 1 - Inner:
32% infil - Custom support

Pt 2 - Center:
99 Bottom layers to make it "solid" - Custom support

Pt 3 - Outer:
32% infil

Pt 4 - Wire Management:
99 Bottom layers to make it "solid"

---