AIO mount for RTX 2080

USE AT YOUR OWN RISK

I bought an EVGA RTX 2070 XC Ultra (which basically has the same PCB as a 2080)
and my Kraken G12 wouldn't fit because it would be sitting on the aluminium faceplate which is higher than it should be.
The faceplate also is used for cooling, so taking it off or cutting it was not an option.

It uses the original screws (M2.5) for the holder itself to mount onto the pcb.
The Fanholder (for 92mm Fans) can be mounted on all 4 sides via M4 screws aswell as other stuff like shields with logos.
On 2 sides there are places for M3 screws so you can mount LEDs onto the holder.

I get 47°C max on Furmark with a Kraken X61 (2x 140mm Radiator) mounted with this holder while using a M2 cooling block for the VRMs.

If your pump mount has grabbers as in the photo it will most likely fit, because underneath the shell there are like 2 or 3 different pumps carrying logos of a lot of different vendors.

As always the source is included.
There will most likely be no further changes or addons since i ordered a custom watercooling loop.