Ender 3 SKR 1.3 Box & Optional 80mm Lid

This is a remix with corrected USB and SD Card holes.

IMPORTANT
Please note I have made some changes.

• The bottom is now totally flat. It's only 0.2mm so screws will easily go right through; however, this should make a much more consistent first layer.

• I changed the holes for the buck converter to align with the one I use

In the spirit of the original author, I have shared my F3D file. This should make it easy for people to fix or adjust the buck converter screw holes.

WIP MODEL - Added a new model with better screw holes that are countersunk which should make screwing in the motherboard A LOT easier. Also made it so the holes that go under the Y gantry arm are now posts. I'm hoping that will make it easier to install because now you can have the board be loose while installing all the wires, then just slide it down over the posts and secure it on the left where you do have access to the screws. Previously, you did not have access to those screws if the box was already installed. This post mod is just theoretical and has not been tested, that's why it's labeled WIP. If you try it and it works, please post in the comments.

Changelog

8/26/19 - Initial upload

8/28/19 - Increased size of SD card hole to increase compatibility.

8/28/19 - Added a work in progress model with posts and better screw holes that are countersunk.