Anycubic Predator TFT35v3.0 Faceplate

Hi folks,
This is my design for a front plate, for anyone who uses the BTT/Biqu TFT35 v3.0 with their Anucubic D (Predator)

I initially made it as a single piece, but to facilitate printing on a predator printer, i seperated it into 3 pieces and it slots together..
(if you have a bigger printer and want a single piece then ask away)

This will require a small amount of sand papering to smooth down any print layer lines and help it slot together.. But, it has been tested, by my friend Davy and it works..(Thanks Davy) (( I have also made a couple of minor design changes since testing, the text below the screen is gone, but i added a snazzy vent over the buzzer..))

I have only uploaded STL for this variation. I do have one for the TFT24v1.1 also if it is required. Feel free to message me.
I can also give out a blank plate if people want to put their own text/pictures in.

I am considering starting my own website where designs will eventually end up too..

UPDATE..........

I have added a small tolerance to the slot design...... I hope you see a difference.
(will probably need post processing still)

I have also made the usb slot slightly bigger (hopefully!)

And there is also an STL included for 1-piece printing if that suits you.. ;-)

Hope its bit better this time... keep me posted if not..

UPDATE 2.......
As per request have added a blank left and blank whole print able parts.....

I have also addressed some issues with the centre panel....
The holes for dial and reset button have been made slightly bigger and the bezel square has been bought in to cover over the unused edges of the TFT panel..