Accessory on/off switch for Anycubic Kossel Plus (for e.g. Raspberry Pi

This is a accessory switch design to fit between the lower extrusions in a Anycubic Kossel Plus.

I'm not sue it it will also fit the smaller Anycubic Kossel versions. Please test and let me know.

The switch can be used for any accessory like a Raspberry Pi or LED strips.

This design is part of several mounts to integrate a Raspberry Pi into the base of you Anycubic Kossel. The other mounts can be found in the links below:
Raspberry Pi mount: https://www.thingiverse.com/thing:3912074
Power supply mount: https://www.thingiverse.com/thing:3912130

There are several versions in this download. The specs of each file can be found in the filename.

• There is a version that fits a 5mm LED, and there is a simpeler version with on/off label
• Boths versions are available for switches with a 5, 6, 7 or 8mm mounting hole.

The optional LED can just be pressed in. For a typical 20mA LED an 580 ohm resistor will be fine.

Mount to the 2020 extrusions using a M4 screw and T-nut / hammer nut.