October 15, 2019
Description
This little thing allows to trigger the X end-stop 1/2cm earlier than normal on a CR10-S Pro.
I recently bought 2 Creality CR10-S Pro but one of them had a problem with auto-leveling.
Every check points on the most left side where not detected by the sensor.
Triggering the end-stop 1/2cm earlier solves this problem.
You can read more about this problem here : https://www.reddit.com/r/CR10/comments/de5pz6/bed_leveling_issues/
License:
Creative Commons - Attribution - Non-Commercial
Anar
