Oral-B charging station switchable toothbrush holder

Did this as a remix from the original charging station for 3 toothbrushes by ujdj27mm18.

Changes:

• redesign for 2 toothbrushes only
• smaller switches
• location for switches from front to back
• redesign of the cable feedthroughs (no tape needed anymore)
• added radiuses on the screw holes on the main case for better printing and stability reasons
• several radiuses for optical reasons
• top united as one single part only

Additional things:

• soldering for rewiring
• shrinking tubes or electric isolation tape
• glueMethylene chloride
• 4x 3,4x16 screws
• 2x mini on-off switches (~15mm length x 10mm width; I used those: https://www.ebay.de/itm/10x-WIPPSCHALTER-WIPPENSCHALTER-EINBAUSCHALTER-MINI-WEISS-SNAP-IN-230V-12V-3A/263078019620?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649)

For main case where the rib is cut out for the cable feedthrough I used support; could also work with bridge feature, but I didn't want to give it a try.

If someone wants the switches on the front or maybe one on the left and one on the right please feel free to contact me, I could design it quickly.