October 27, 2019
Description
I needed to replace a drain as the shield on mine kept moving and coming off. I found the tool made by jnads was too big for my drain to I remixed it a little smaller (to 38mm) and the openings at the bottom was a little smaller than the diameter of the tool.
I also had a 30mm 1/2" drive socket so that's what I have as the hex at the top and was used to remove/install the drain.
It worked well and just putting it out there in case someone else has a similar drain as mine.
I printed mine in PETG with the same settings (5 perimeters and top/bottom) as jnads.
License:
Creative Commons - Attribution