Laser Cut Desiccant container R2 (screwless)

This is new and improved version of Laser Cut and 3D printed desiccant container (https://www.thingiverse.com/thing:3932207).
This one is purely laser cut and doesn't use any hardware to keep it together. Instead it uses "elastic clips" (https://www.thingiverse.com/thing:53032) design.
One huge advantage over version with screws is that this one potentially can be used in microwave to refill/dry silica gel bids without need to open container and remove bids first.
However I haven't tried microwaving it, so please use at your own risk!!!

How to use:

1. Laser Cut Top, Bottom, 2x Long Sides and 2x Short Sides from 1/8" (3mm) acrylic. This will work with acrylic up to 3.1 in thickness.
2. Peel off masking tape
3. Very carefully assemble enclosure (flex/elastic clips are fragile).

• Short side has to be installed with elastic clip facing up, and two cut out slots on the bottom
• Long Side has to be assembled with protruding (teeth) on top
• Attach both long sides to one short side first.
• Insert bottom part into short side's slots
• Insert remaining short side from the other end and clip together.

1. Fill container (with top cover off) with fresh silica gel bids
2. Carefully close top lid.