Nimble V2 mount kit for Cartesian and CoreXY printers

Modular print head to mount a Nimble V2 or cartesian or CoreXY type print heads. This covers a wide range of printers, like the Hypercube, D_Bot etc. The Generic mount can be used to design your own mount. Simply add the backplate needed to mount it on the carriage.
Added here are mounts for the HEVO, D-Bot and a i3 backplate.

There is a 5015 fan mount and a duct that fits both the E3D V6 and the Mosquito. Also included are 3 different sensor mounts for the bed leveling sensor.

Both mounts (for the V6 and for the Mosquito) can be used with the standard hot-end fan or a 40x40 fan, using the relevant part.

Since the introduction of Version 2 of the Nimble and Sidewinder, they share the mounting points. This means that these mounts are suitable for both the Nimble V2 and the Sidewinder V2.
The Nimble V2 has a drive cable that exits vertically, while in the Sidewinder V2 the drive cable exits horizontally.

#####Changelog:

• 1 Initial release.
• 2 Tweaked the BL Touch sensor to give it a little more space with the 5015 duct.
• 3 Cleaned up the Air Ducting part.
• 4 Added a Hevo Mount with an M3 locknut opening, instead of insert.
• 5 Added a default mount and fan frame for a Volcano hot end.

You will need various M3 fasteners, depending on which version you need.
For our USA friends, it is easiest to buy a kit like this:
M3 fastener kit

Note: Some of the holes are blanked with a 0.2 mm layer. This is to allow the nut pockets to be printed properly. It is easier to bridge a flat surface than to bridge a surface with a hole in it.

The STL models are checked and optimised.

The Nimble Extruder Version 2

These parts are ONLY for the Nimble and Sidewinder Version 2.
With an installed weight of less than 25 grams on your carriage/effector the Zesty Nimble is the smallest and lightest extruder you can buy, it has ample torque and can be mounted in multiple orientations.

The Nimble is available from Zesty Technology.