Summary

My version of Leela's wristband computer with holes for magnets to hold together

Used a stack of three 2x1mm neodymium in each hole (24 total holes)

Print Settings

Printer Brand:

Prusa

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Mk2.5s</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.20mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15%</p></div></p>                                                    <strong>Filament:</strong> Prusa PLA                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>NEEDS a brim because of very thin bed contact</p><p>Recommend printing upside down because of angle needed for support.</p><p>Had best luck with 3 perimeters, 15% rectilinear infill.</p><p>If infill is printed too fast, piece has a chance of shaking off the bed.</p></div>

Post-Printing

Sand, primer, sand, primer, paint, mask, paint, clear coat, HEEEEEYAH!

Super glue stack of three 2x1mm neodymium magnets into each hole, making sure a tiny amount of the magnet sticks up enough so it can contact magnet on the other half. Obviously need to be real careful about the orientation. Do this part at some point before the final paint coat.

Leela Wristband - Futurama

Leela Wristband - Futurama

Related Models