Spin Gear V3 (Beyblade Part)

An improved version of Tightskin's spin gear design, which I was inspired to make after getting my first official plastic gen beyblade. Many changes have been made to this, so that parts of it can be properly mixed with those of official spin gears. Also, the sides of it are now inscribed with either an L or R, depending on the spin direction it grants (left or right), so it's easier to differentiate between them once printed. Also, one of the changes is that the hole at the bottom of the core has been widened sightly; the metal tip of Customize Change Base actually requires it, as one of the pictures shows.

A couple of the included photos show a comparison between the three different spin gear versions that I've made. The yellow one is this version, the red and blue one is an official one, and the white one is Tightskin's version.

Also, when I was looking closer at the core file, I found out that it was actually two different pieces all along. I've put separate and combined versions of this. If you print the separated version, you can insert a metal cylinder, though you'll need glue to keep the two halves together.

.

The Spin Gear is at the center of a beyblade, holding every other part together. This itself is made up of two parts, which I call the core and shell. The core is meant to hold weights of different kinds, usually being regular metal or a magnet. The shell determines the direction that the bey will spin in, and allows the beyblade to connect to a launcher.

The core fits in to the shell by lining up a rectangular tab on the core with a similar rectangular slot on the inner part of a shell. A second shell is needed for full assembly.

To attach it to the blade base, slide the bottom of the assembled spin gear on to the matching space in the blade base. When fully inserted, you should be able to press the pegs of the blade base all the way in to lock the spin gear in place. Two small tabs at the end of the pegs should hook on to the circular bottom lip of the core.

Weight disks have two pairs of tabs on the inside, with each tab of each pair being separated by a small, rounded notch. This notch should line up with rounded tabs on the sides of the spin gear. The weight disk will be a loose fit, and won't directly lock in place. Rather, once the attack ring is attached, the weight disk will be clamped between the spin gear and attack ring.

The attack ring has two wide, thin, inner tabs on its bottom. The top of the spin gear is almost a perfect, flat circle except for two wide notches. Line these up to attach the attack ring, and twist it as far as it will go. If everything worked right, the inner tabs of the weight disk should be completely covered by the attack ring.