Custom skin for Geekvape Aegis Mini

Made with OpenSCAD, source files on GitHub: https://github.com/Depau/aegis-mini-skin

Not perfectly accurate but almost, fits perfectly. Buttons included.

Printing

Print the main skin with the round part facing up, support material enabled.

The small buttons are fine without supports as long as you keep them with the base facing down.

The big button needs supports so that the button pusher doesn't fall apart.

Assembling it

The plastic skin on the back can simply be unscrewed and replaced.

In order to replace the buttons, you need to remove the screw holding the USB port cover, then stick a knife on the side of the screen and pull it up with a bit of strength. It's a big piece of plastic held together with strong double-sided tape.

Doing this should not affect impermeability: there is another plastic screen behind that held down with screws and with a gasket. However, I don't take any responsibility for that. I still use mine in the bathtub and I've taken it apart several times, but your mileage may vary.