Liquid soap/hand sanitizer dispenser for single hand/forearm use.

[8/6/20 V2 hinge pin uploaded - now contoured and sized to sit flush against the main body for a much nicer look.

I did design a variant that had a much less bulky body, but it ended up using practically the same amount of filament due to the amount of support material needed].

A simple application of a lever to make pushing the pump easier.

Perfect to folk with weaker wrists, arthritis, larger tools etc.

Functioning base designed for a bottle with a 27mm diameter neck, and a 30mm diameter lid. You may need to shave the inner ring a little to adjust to fit perfectly (it's a tight fit!)

Works best if the bottle has quite a wide base to prevent it from toppling. Results may vary with different bottle shapes/sizes!

The design should scale up without an issue but may need a little rework if scaling down, due to clearance tolerances being designed for this sized print.

Included is also a base without a hole in the bottom. Will accommodate any diameter lid up to 30mm - all you need to do is add a hole in the centre of the recess to accommodate the diameter of bottleneck you need.

PLEASE POST YOUR MAKES/REMIXES!

Please respect the CC licence and share with the same settings - assistive aids should be free and open-source!

Prints without supports, however, you may want to enable supports just to help out the curve around the hinge area get started.