March 28, 2020
Description
This funnel was created for doing oil changes on Toyota/Lexus/Lotus engines which use a M37x3.0 thread on the oil cap. I printed it in PLA and it is about 120.7mm tall and 122.2mm wide, just in case you need to adjust in your slicer. I used Cura and flipped the funnel so it would be large end down against the plate and I did not use any support but I did use a brim for extra stability and I used 20% infill which I found is super strong.
Hope you enjoy it!
License:
Creative Commons - Attribution
RapidLotus
