Easy 3D printed Face Shield extendend - trimmed, Now with Vents

remixed by shaving down the thickness of the band to save 5 minutes off print time.

Print this file: thin-band-noHoles-shield.stl

See this video for easy installation of the shield film:
https://www.youtube.com/watch?v=xsc1RIfQK8s

For added over-the-head protection like the NIH approved DIY shield, see the file: instructionsAndTemplate.pdf

HOWTO:
1)Insert film by deflecting the outer rim at the front just enough to see the inner rim.
2)Then while holding the deflected outer rim, insert one corner of the film towards one earpiece and release the deflected outer rim.
3)Working from that side, pull the film through the slot equally all the way around.
4)Slide the outer rim back into place thereby locking the film between the two rims.
NOTE:)You may want to trim 5-6" off the bottom if it's too long.