Rising Sun - War Banner Marker

Hi,

I created those replica of the Kikstarter War Markers for rising sun, since i do not love the cardboard token.
Here on thingiverse there is not a valid alternative in my opinion, so i did this weekend job to pimp my version of Rising Sun Boardgame!

[Really Thanks to "Mazzi" my friend from "IRDA" - Il ritrovo degli Avventurieri, Tradate (VA) Italy for this awesome Gift]

Now, what you shall print?
You will need:

• 8x RS_Flag_Bases:
  Those are the base of the flags. 1x Flag
  Print in WHITE (or your preferred base colour)
  NOTE: The base need to be rotated in order to be printed correctly

• 16x RS_Flag_Main_Body:
  This is the Flag Body, you will need 2 of them printed, and the glue togheter with the correct number inside.
  Note: You need to flip half of the bodyes (8x) in order to be able to glue them.
  Print in WHITE (or your preferred Flag colour)

• 2x RS_Flag_RedFilling_Nx:
  You will find the 8 files numbered 1 to 8.
  For each number you have to print two copies.
  Print in RED (or your preferred colour)

After print the flag must be glued (i used cyanoacrilate CA).

• Take the red token with number and place on the flag body hole,from the inner side (the part of the flag attached to the bed of the printer). Check the correct orientation of the number!

• With a point of glue on the inner side, attach the red number on the flag hole

• Take the 2 flag side (Same number!!) and put glue on one side (bed side of the flag). Then, glue togheter. check the alignement.

• Put the flag into the base. it should enter well.
  If loose, glue it,
  If thight, take a 2.5mm drill bit and refine the hole.

• At the end, use a Permanent marker to paint the number on the flag. i used Black instead of white because i preferred it (but you can do what you want, obviously)

Hope you love it and do not have any trouble to print them.