April 21, 2020
Description
This NAS case is 4-bay.
Since I am not a design expert, there may be places where specifications are not met. In that case, use a hammer. I also used a hammer.
This NAS case requires 3d printed output from the following link.
https://www.thingiverse.com/thing:3560809
The parts that go into this NAS case are:
-Small development board
-Sata to usb (HD-500SATA-A)
-Other parts as required
It was also confirmed that the heat generated from the hard disk could not be discharged while the NAS was being built and used. Therefore, it is recommended to put a cooling fan behind the case. Specifications are 80mm wide and 10T thick
Thank you for reading the poor English of Google Translator so far.
License:
Creative Commons - Attribution - Non-Commercial - No Derivatives
dltkddnr04
