Dr!ft 1:43 D1 integrated FPV mount

I test printed this both in PLA and TPU and both seemed to held well.
The FPV camera I use with this print is:
https://www.banggood.com/14_5-Inch-CMOS-700TVL-120-Degree-5_8G-40CH-25mW-FPV-Camera-VTX-3_3g-Only-For-Mini-RC-Drone-p-1358703.html

The camera sits in the slot and the VTX unit sits sideways just behind the camera.
You will need a new connector to attach to a battery that gets slid via the back window.

For all this to work you will need to cut out the front window and the rear window.

I've also added a slot for a micro switch in the front window which can be used to turn on/off the VTX in a faster maner, in case you dont want to remove the battery right away.