April 30, 2020
Description
This is an extended version of submano's cooling fan duct for the Ender 3. I found that it did not fit my Ender 3 and remixed this to correct that. It is 1.8mm longer in the middle.
The original got too close to the silicone sock and deformed, and also blocks less of the hot end fan draft.
Note: As with the original design, PLA is probably not suitable due to it's lower heat tolerance. I printed it with ABS, and submano recommends at least PETG.
Remix of: submano's cooling fan duct
License:
Creative Commons - Attribution - Non-Commercial
Sklab
