May 17, 2020
Description
These are 3D printable brackets to construct your own pedalboard. I had most of the hardware on hand, so over all this was a much cheaper route as opposed to dropping $$$ for a pedalboard of a similar size.
My version uses 500mm 2040 aluminum T-slot extrusions (5 series). Use M5 x 8 screws to fasten together. Change the length of extrusion to fit your needs. To give a cleaner look I also used off the shelf end caps. If you don't have end caps I highly recommend filing down the edges of the extrusions.
License:
Creative Commons - Attribution - Share Alike
roijeric
