Lathe Chuck Key Holder and Quick Change Tool Post Holder

There were a few AXA quick change tool holders out there but no AX0 that I could find. I tried these in a few infill options. For the tool holders, it didn't make much difference from 15% to 100%. For the chuck holder, I ended up doing 100% because they key was much heavier than the tool holders. I may reprint in ABS, but it seems it will hold up fine at 100% infill. I didn't use support on any of these, but the chuck key holder came out a little shady a couple of times (you can see in the pics) so it may be cleaner to print that one with support.

This is for the 8 x 16 budget lathe.

Both of these have 2 each 12mm x 12mm x 2mm holes to attach the magnets at the link below. They are not needed but they do help hold the tool against the splash guard.

Chuck holder is:
40mm wide x 40mm deep x 40mm tall
22 mm hole
12 mm cross bar

AX0 holder:
40mm wide x 28.5mm deep (without the tool attached) x 40mm tall with a 14mm gap to fit over the splash guard

Magnets:
https://www.aliexpress.com/item/32837865493.html?spm=a2g0s.9042311.0.0.27424c4daHOvzV