This is an all in one case for a Raspberry Pi and touch screen. There are buttons on the side of the touch screen. Small 3D printed parts make it possible to use the buttons with the touch screen installed in the case. Five 3D printed buttons are required for the full assembly.
The Pi can be quickly removed (one screw) and there is room to make more connections to the Pi via USB.
The box was lasercut from .2" thick plywood from Home Depot. (purchased in 4x8 sheet). the OpensSCAD file is included and the material thickness is a single variable input in case you want to adjust the thickness for you material. The flat pattern can be exported from OpenSCAD as a DXF or SVG file.
The electronic components are listed below:
Element14 Raspberry Pi 3 B+ Motherboard Element
https://www.amazon.com/dp/B07BDR5PDW/ref=cm_sw_r_tw_dp_U_x_XPv0Eb669NGXB
Miuzei Raspberry Pi 3 B+ Case with Fan Cooling and 3× Heat-Sinks, 5V 2.5A Power Supply with On/Off Switch Cable
https://www.amazon.com/dp/B07BTHNW9W/ref=cm_sw_r_tw_dp_U_x_IQv0EbRDYCGEH
ELECROW 5 inch Capacitive Touch Screen 800x480 TFT LCD Display HDMI Interface
https://www.amazon.com/dp/B07FDYXPT7/ref=cm_sw_r_tw_dp_U_x_PNv0Eb980FSQ3
Combo HDMI 90 Degree and 270 Degree Right Angle Male to Female Adapter
https://www.amazon.com/gp/product/B00Y7UT6EK/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1
** Don't get two 90 degree or two 270 degree. The 90 and 270 degree adapters bend in opposite directions.
I used #6 x 3/16 Long sheet metal screws for the screen but #4 might have been better. I had to enlarge the holes in the LCD screen a little bit to get the screws through.
The screw keeping the Pi from coming out is a #6 x 3/8 long sheet metal screw.
scorch
