Makita drils and drivers bit holder

Hi,

This is not actual remix - it's made from scratch - but heavily inspired by Gertsen model.

I've made it because Gertsen models did not fit exactly on my Makita tools, and I also wanted to have option for both left and right side installation. Finally I think it's better to add magnets on the bottom, for holding bits. Not that they where falling out so far, but it's easier to pick it up when it's hold by magnet and not by friction.

There are two version, one to be used without magnets (bit holes are slightly smaller) and another with holes for 10x5mm neodymium magnets.

Both are in left or right configuration.

You can print it without supports - the upper lip won't be prettiest this way, but it's something that is on the Makita device side and it's completely invisible after installation.