New updated version with larger air intake. Now supports both 18" and 19" wheels and also both the original smaller brake calipers and the larger brake kit (see note below).

For 60mm hose (inner diameter)

PRINTING:

Can be printed without supports. Print the scoop with it's air intake opening aiming down towards the printer's base plate!

If the scoop doesn't fit try placing it at 45 degrees diagonally over the printing plate
.

Print one scoop as is for the left side and print one mirrored for the right side

.

MOUNTING:

Mount the scoop as far away as possible from the car center. The closer to the wheel the more room it has to accommodate a turning wheel. Check out the pictures above!

Note: For the larger calipers in the upgraded brake kit mainly found on M2 Competition, reverse the left and right scoops so the air hose tube is closer to the car and mount the scoop as close to the car as possible instead of as close to the wheel as possible for the smaller original brake calipers.