Raynox 150/250 covers

IMPORTANT, THIS DESIGN IS NOT ALLOWED TO SELL!

The case supplied with the Raynox 250 magnification macro lens is ridiculously large so I designed this simple yet effective rear cover and front lens cap.

Print without support. After print, wiggle the tabs slightly and then place the cap with a tab towards a hard surface and push firmly until it snaps loose. Do the same for the other side. There's only a 0.3mm gap in the design so it will probably stick together somewhat. I've printed in 0.15mm PLA and PETG without issues.

As always, if you find it useful a tiny donation goes a long way to show appreciation. :)

For more sizes of the same cap look here: https://www.thingiverse.com/thing:4418284

EDIT: Added an internal thread in the rear cover so the front cap can be parked when the lens is in use.