Tesla 2-color Hitch cover for 2 inch receiver

edit 2020.07.17 : Added an alternate offset 5mm insert piece to align with base of the 2inch receiver.

---

This is a 3 piece Tesla Hitch cover with an insert for 2 inch receiver.

Note that the insert has to be glued properly for it to work robustly outside without falling off.

In my own printout, I used a glow in the dark PLA for the middle white layer and a solid black ABS for the other two pieces. In theory you can use any combination of colors that matches your own car.

After assembly, I sprayed on a layer of polyurethane for a glossier finish.

In my own print, the fittings are a bit tight so if you paint them separately, be prepared to do some touch up to remove paint from the middle.