CREALITY CR10S PRO SPOOL HOLDER WITH BEARING

Here my design for the spool holder with bearing or not, that I created for my Creality CR10S Pro. I used Fusion 360 to realize this project.

For the spool holder himself, you will need to mount it on the printer frame with: 3 x M4 x 8mm screw/T-nut For V1 and 4 x M4 x 8mm crew/T-nut for V2

ARM_BEARING_CR_V2 and ARM_BEARING_CR_V2.1 share the same design with a different length. Both have main shaft with bearing at the end.

ARM_BEARING_CR have bearings sit on pins.

SHAFT_BEARING_CR_V2.1 go with ARM_BEARING_CR_V2.1 (Short version: 72mm spool width max.)

SHAFT_BEARING_CR_V2 go with ARM_BEARING_CR_V2 (Long version: 87mm spool width max.)

PIN_BEARING_5MM go with ARM_BEARING_CR ( Single version: 77mm spool width max.)

arm without bearing (Short version: 77mm spool width max.)

arm_long without bearing (Long version: 87mm spool width max.)

For the arm with bearing, you can use R1450ZZ or 605ZZ Shielded Ball Bearing, inner diameter is 5mm, outer diameter is 14mm and width is 5mm.

For the Filament Guide see: https://www.thingiverse.com/thing:4317259

Plain means no logo, and XS means stronger version