This is a remix from omikr0n's " Garmin Fenix 5 QuickFit bike mount " .
If you found this design very helpful or otherwise wish to buy me a cup of coffee
( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :
Since i have the Fenix 5x plus ,the bike mount from omikr0n did not fit
my watch and thank's to omikr0n had put the fusion360 original file
in the download folder ,it was simple to change the mount to fit the
Fenix 5x plus and i have adjusted several things ,so the slider moves
really well ,plus i made some tiny tweaks here and there .
The zip ties do not go straight through anymore but now follow the curve of
the bottom of the bike mount ,can't say it is better ,but if you put some
rubber pads underneath the bike mount , the mount sits really well on the
stem .
You can use a zip tie up to the size of 4.8x1.4mm ,but use a smaller version
if it is too hard to push through .
Regarding support for the model , i have created support pieces that fit the
bike mount ,it is up to you if you want to use them .
The small bracket in the back that hold's the spring from not jumping out ,
i recommend that you print this with the little "knob" facing up and make support
underneath the two sides ,this make the bracket grips better in the bike mount,
when you push it down into the mount .
Regarding the "spring" , i used a spring from a pencil and cut it in 2 half's ,that
size fits perfectly
8orge
