Flite Test Mini motor mount (EXTRA NARROW)

I had a few builds where I needed a extra narrow mighty mini motor pod.
Basically I added doublers to a mini nose that was taking a beating, but the stock motor pod no longer fit.

This is if you have a motor area that's about one or two foam-board widths narrower than stock.

I added a template piece to help you reference where the holes should go. it has a long side and a short side (with a little extension on one side) to account for the motor pod firewall being at an angle. you may not need or want to use it for alignment, I just like providing options!

The holes are 4mm wide, and 20mm apart center to center. and about ~9mm from the nose of the foam-board to the edge of the first hole.