ScatterCannon Back Rail

Low profile picatinny back rail for The ScatterCannon blaster that replaces the back sight

Requires 5 small screws like used in the scattercannon assembly

Print in default orientation with supports touching build plate

To install
1 Remove the plunger tube, plunger and spring retainer pipe from the blaster then reassemble
2 Insert BackRail B into the back sight recess with the slotted end facing foward then screw in
3 Insert the tab of BackRail A into the slot on BackRail B
4 Using the screw ports in BackRail A as a guide, drill pilot holes into the shell using a 2mm drill bit, being careful to only drill as deep as needed
5 Remove BackRail A and clean up any burs around the pilot holes
6 Reinstall plunger tube, plunger and spring retainer pipe and reassemble blaster
7 Insert the tab of BackRail A into the slot on BackRail B and screw into shell