July 10, 2020
Description
I have the V1 Candy dropper from Hobby King but it is heavy and lots of drag, so I designed this light weight and low profile plate. The servo controls push rod to release a rubber band holding anything on the bottom of the Tundra.
Needed to make it work:
1x 12g servo - I used a TowerPro MG90S
1x small zip tie to hold the servo wires in place
1x M3 screw to hold the rubber band in place
2x screws to hold the servo on
1X push rod wire
License:
Creative Commons - Attribution - Non-Commercial
aGard83
