August 7, 2020
Description
Rather than constantly trying to thread a needle loading the filament into My new Sidewinder Runout Sensor; I created a quick casing that has a large elliptical lead in for the filament. The case slides over the sensor easily from the filament loading side and the bottom tab flexs until fully seated, then retains the sensor. I printed in orientation shown with supports.
May work on other printers using this sensor.
Take a look at my other sidewinder X1 upgrades:
https://www.thingiverse.com/thing:4784042 Artillery Sidewinder X1 Extruder Cover V4 w/ Strain Relief
https://www.thingiverse.com/thing:4783250 Artillery Sidewinder X1 Left X Cover with Cable Strain Relief
https://www.thingiverse.com/thing:4774786 Bed Heater Strain Relief Artillery Sidewinder X1
https://www.thingiverse.com/thing:4592828 V Slot Frame Spool Holder
https://www.thingiverse.com/thing:4839858 Artillery Sidewinder X1 TFT Plug Guide
https://www.thingiverse.com/thing:4849418 Light Bar (ASWX1 or other 2020 3D Printer Frame)
https://www.thingiverse.com/thing:4858847 Full Width Light Bar
https://www.thingiverse.com/thing:4863723 Sidewinder X1 Easy Firmware Flash TFT Switch Mount
License:
Creative Commons - Attribution - Non-Commercial
658
Dzinr
