AK 12 CONVERSION KIT - DEMO

!GET FULL KIT HERE: https://cults3d.com/en/3d-model/various/ak-12-conversion-kit-gen-1 !

Assembly video: https://youtu.be/2or_MVLOdnI

Please READ all the description

https://www.facebook.com/3DprintedAirsoft

AK 12 conversion Kit. This kit will make your AK 74 to looks like AK 12

Changelog: 29.7.2020 GEN 1 - published

! Before we start, you have to make sure your gun is compatible, this version is make for airsoft guns with steel recievers and rivets ( you can found picture in "photos" ) ! if you are going to use "K" version and its flashhider, before you cut the barrel, measure it all precisely

Grip:https://www.thingiverse.com/thing:4127235
Stock:https://www.thingiverse.com/thing:4080324

Whats des this kit contain:

Lower handguard
Lower handguard - experimental
Upper handguard
Lower and upper handguard merged to one
Handguard pin
Gas tube
Rear sight block replacement
Ris rail for dust cover
Ris rail assembly for upper handguar
Front sight ( 2 versions )
Front sight cap
Muzzle "end" ( 2 versions )
Quick attachable muzzle device
AK12 "K" muzzle device
Rear sight frame
Dust cover lock ( 2 versions )
Dust cover lock buttom
For what ak lower:

All its need to have barrel assembly like lower on this picture:
https://airsoftpro.cz/en/gun-parts-upgrade/aeg-outer-spare-parts/ak-parts/gun-body-for-ak/ocelove-telo-pro-ak-74-se-sklopnou-pazbou-detail
This kit will NOT BE COMPATIBLE with lowers like: ( most of plastic guns ) https://airsoftpro.cz/en/gun-parts-upgrade/aeg-outer-spare-parts/ak-parts/gun-body-for-ak/plastove-telo-pro-ak47-detail

What will you need:

Basic tools for 3d prints finishing
Drill
4x low profile M5 nuts
5x M5x10 screws
Stick with 5 mm in diametr, it will be cuted to 15 mm, 24 mm and 34 mm length and to be muzzle locking pin
Stick with 3 mm in diametr, it will be cutted to 12 mm lenght
Some springs
Front sight from Sight block
1x M3 headless screw for "K" flash hider
2x M3x10 headless screw for dst cover locking mechanism
1x M3x10 headless screw for sight frame
How to attach handguard:

You will need to drill hole to lower reciever, this is drastic change, so be carefull, there is template in "Photos", print in as A4 and check dimension acording "size check" on the template
I DONT WANT TO CUT BUT STILL USE THIS KIT - sure you there is "lower_handguard_experimental, it use 2x M3 crew and nut to secure it to barrel, its called experimental, because i did not printed it.

What parts to print:

Depending on your barrel, choose "screw holes" or " pin holes" parts, this kit was mainly for barrels that use screws to attach gasblock etc, but also there is version for barrels that use pins like real thing does, i have not tested pin holes parts but they were done according to measures from cyma AK 74.
I DO NOT CARRY ANY RESPONSIBILITY ABOUT DAMAGES ON YOUR PROPERTY YOU MIGHT DO