I modified this great design to make it stronger as I found the original a bit too bendy.
To maintain strength the arm and wall clamp need to be printed on their side with supports for the arm. Using PETG or similar strong material. It will print well in PLA but may become brittle and snap!
One M6x80mm socket cap bolt and M6 nyloc nut or similar are required per speaker.
The speakers tilt forward a few degrees which is just what I wanted. They rotate left and right by about 45 degrees.
I suggest at least 4 perimeters and at least 1.2mm thick layers with 30%+ infill. Good layer adhesion and closer to solid the better!
Added R2 wall bracket for cleaner printing.
If you like or use this please send me a little support, just a pound or two (or dollars etc) at [paypal.me/MettaUK](https://paypal.me/MettaUK/ "Help Me") Thank You
MettaUK
