###Overview
This design is for a modular electronics enclosure for 3D printers. It utilizes a enclosure / tray system, which allows users to create a new tray if different electronics are needed. This configuration is setup to support an Mainboard (MKS Gen L, SKR 1.3, SKR 1.4, SKR 1.4 Turbo, & SKR Mini) , External Mosfet Board, and Raspberry Pi. All Hardware used in this design is M3.
###Revisions
Initial Release - September 5, 2020
Updates to design; Lid closure fasteners from one to three, added stl files for skr mini. - October 25, 2020
###Detailed Description
This design was intended to be fully customization for other users. As it features:
- Simple tray system for mounting all electronics inside the housing
- Simple I/O panels which can be changed
- Mounting locations for the housing on two different sides
- Plastic knock-out features for cable egress
The current configuration uploaded is optimized for:
- MKS Gen L/SKR 1.3/SKR 1.4
- External Mosfet
- Rasp Pi B+
Current Hardware Needed:
- 6X - M3 Hex Nuts
- 17X - M3X10mm Screws
- 1X - M3X25mm Screw
- 2X or 3X - M6 Screws for mounting onto your printer frame
Printed BOM:
- 1X - Blanking Panel 1
- 1X - Blanking Panel 2
- 5X - 1mm Spacer
- 1X - Base
- 2X - Hinge Pin
- 1X - Electronics Chassis
- 1X - Lid
###Print Settings:
Material: PETG or ABS
Infill: 30%
Layer Resolution: 0.2mm
Support Needed: No
Rconroy
