Face Mask Frame

This is a Frankensteined remix of the inner frame of https://www.thingiverse.com/thing:4200485 Thank you FacFox Henry.
I've beefed-up the ribs a bit and tweaked the angle of the nose piece and chopped off some excess with a 'plain cut'.

This mask support should be lined on the nose and chin piece with something like moleskin (found in the foot health department) or cut pantyliner etc. These two points should be the only contact points with the skin. Clean or replace lining daily for good hygiene.

Measuring from the bottom of the nose to the bottom of the chin + 15-25mm will be a good size gauge. Remove 'Uniform scaling' and simply shrink or expand the large model lengthwise to meet size needs.

Works well with deposable and cloth masks I've tried. Adhering the frame to mask with small strips of '2-sidded mounting tape' works well, with top of nose-piece about 1/3 - 1/2 inch below nose wire of mask; The nose piece is intended to set on the end of your nose without touching the rib/arch of the frame.

Initially, you may feel the frame/support is breaking the seal of the mask, but be sure you are not simply enjoying more free breathing. Enjoy breathing again!