September 21, 2020
Description
This is the final version of my 'Vistapick' creation. It has been so cool seeing my mount being used far and wide and on so many different frames. Please tag me in any insta (@bludzfpv) or facebook (@HaloRC) so I can see it in action. Or share YouTube links in the comments below.
This final version is as short as possible, only 1-2mm clearence between FC and Vista. If using the DJI TX you can cut the base down to make it lower but you will need shorter than the recomended bolts and you will have props in view at higher camera angles than I recommend.
Parts required...
4 x M1.6 x 20mm bolts
1 x Frame with toothpick board mounting (HaloRC Odin
https://halorc.uk/products/frames/odin/
is the frame I design specifically for this mount and setup)
4 x motors 1404 Xing are awesome, the new Emax ones look good too but the kv is a bit low for me.
1 x AiO Toothpick size FC
1 x Vista
1 x RX if required
Props I like to run are HQ 3x1.8x3
Lipo 850mah 4s gets me 2 mins 20 seconds at 80-100% throttle on a race track. 8 mins + just freestyling. All still way under 250g and has tons of power.
License:
Creative Commons - Attribution - Non-Commercial - No Derivatives
BludzFPV
