Xbox Series S Air Purifier / fume extractor

Turned the Xbox Series S design into an air purifier or fume extractor for soldering!

NOTE: This is perfectly just a few millimeters smaller than the Ender 3 bed size. so if you're going to print it on an Ender 3 make sure to print without a skirt or brim! If it's still too large for your printer, double check your printer settings and make sure the bed size is set accurately to what your printer's bed size really is. For me my default settings in cura was 220mm but in reality my bed size is actually 235mm so i had to adjust this. good luck!

This is designed to work with m4 hardware and a 120mm fan.
Watch this video for more details: https://youtu.be/vKu5INImoDk

All links below are affiliate links. It doesn't cost you extra to buy through those and I just get a tiny commission. Thank you for supporting my channel!

Carbon Filters:
• Amazon: https://amzn.to/2GRfllt

This I project uses M4 hardware. I recommend this kit:
• https://amzn.to/30K4JfD

Any 120mm fans will work for this. For the quietest results I recommend Noctua fans:
• https://amzn.to/3jFcNWo

Cheaper 120mm fans:
• amazon: https://amzn.to/3jJZDHx
• ebay: https://rover.ebay.com/rover/1/711-53200-19255-0/1?mpre=https%3A%2F%2Fwww.ebay.com%2Fsch%2Fi.html%3F_trksid%3Dp2050601.m570.l1313%26_nkw%3D120mm%2Bfan%26_sacat%3D0%26_from%3DR40&campid=5338748275&toolid=10001&customid=fan

Push-button:
• https://amzn.to/36E0pSO