Pokeball Classic

A more futuristic version of the pokeball can be found here:
https://www.thingiverse.com/thing:4657519

EDIT 2: Fixed tolerances again, and also now I can say its out of WIP!

EDIT: Fixed some tolerances, note that you may need to use a drill bit to clean out the hinge.

My brand new Pokeball design inspired by the work done by NeoTendar and his beloved Pokemon Unlimited Project https://www.deviantart.com/neotendar/gallery, with his permission to try and recreate! The Pokeball in this Thing file is a more classic version with some twists, a more closer inspired version of NeoTendar's Pokeballs with the glowing slits in it is still in the works, having a hard time replicating those slits in Fusion, he told me he used Maya.

The pokeball can be Fully printed, or, if you chose, you can use a metal RGB button which can be wired up to glow, the files are already ready to take the adafruit 19mm Rugged Metal On/Off switch https://www.adafruit.com/product/3426 . I don't know how to make them glow yet, but I am learning, I intend to properly wire it up with the glowing slits in the next version of the pokeball.

There are 2 bottom half files, one to help support the metal button if you so chose, or one without.
To complete the hinge, you should be able to fit a piece of filament into the hinge system.
Both the top and bottom shell are the same, so you only need to dupe the shell file.
For magnets to keep it closed, i used magnets which are around W=4.5mm, L=9.5mm, H=1.5mm, so if you find any in that zone, all good!

I am yet to print it since I just finished modeling it, but I'm excited to see how it goes! If you have any suggestions please let me know!