I needed a stand to mount my Arduino Mega 2560, a standard-sized 16x2 LCD display, and a full-sized breadboard. So, I whipped one up in Fusion 360.
Some notes:
- While designed to fit the Mega 2560, the left four holes also allow mounting of a standard Arduino Uno board. The hole positions should be the same.
- The holes are sized at 2.5mm, but often end up smaller than that. Depending on the screws used, you may need to enlarge these holes with a drill bit just a bit.
- Screws I used to mount my boards: M3x6mm self-tapping or wood screws should do the trick.
- To fit the breadboard into the tray, you'll need to clip off the small male breadboard connectors typically used to join multiple boards together. I did this purposely to avoid small bits and wires from getting stuck in there.
I've also provided STL, STEP, and Fusion 360 models for you to customize to your own needs.
Mr_Spiffy
