Eufy Robovac 11 30 Broom Gear Replacement

I printed several times this gear and broke, so I was tired of doing this over and over again, so I re-maked with a different approach, lower shatf hole, solid broom holder

You will need to use a dremel to alter the holes on the brooms so it can fit in this design.

Don´t drill too much so it can enter by pressure.

This round design will spread the axial load more efficiently. It wont be as OEM, won't look great, but IT WON'T BREAK.

Is really hard to buy one of these motors, so, If this helped feel free to share, print and use at your will.

Be sure it have the following measures: X:23.55mm Y:23.55mm Z:13.00mm

Print the washer to put below the gear.

The 3mf have the project for Prusa Slicer

Ender 3

0.2 Print Width, 0.4 Extruder,

Gear (bottom part)
0.3 layer height, 20% infill, 3 walls

Broom Holder
0.18 layer height, 0% infill, 15 walls

Enyou