December 6, 2020
Description
This is a box for Raspberry PI to be mounted on a DIN rail.
It got room for a standard HAT.
In the kicad files you can find our example HAT complete with schematics. It is intended for applications where the RPi will sit embedded in some place powered from 24 Volts (instead of typical 5 volts) and connected to an ethernet.
This is PCB ready for production, just send it to JLCPCB or similar service. The other components can be found at Digikey. NOTE some components are surface mounted so this is not a project for beginners to start with.
On top of our HAT we also had a display:
Displaymoduler - LCD, grafiska Röd, grön, blå (RGB) TFT - färg SPI 1,54" (39,12mm) 240 x 240
https://learn.adafruit.com/adafruit-1-3-and-1-54-240-x-240-wide-angle-tft-lcd-displays/pinouts
digikey:1528-2580-ND
If also using the software here it will show useful things like name, time, temp and IP address on the little display. This will help a lot when installing and setting up the networking.
The above should be usefull as it is. If you need a custom HAT we can give you an offer to make one for you. Or if you need a custom box of any sort we can give an offer on that too.
Find our email at:
http://www.eit.se/contact/
License:
Creative Commons - Attribution - Non-Commercial
xehpuk
