Magnetic Bit and Part Holders for Ridgid Impact / Drill

Update 2021-01-26
Designed a new side bit holder. It holds 6 bits long or short and uses 6 12x2mm magnets and one M4x6-8mm Cap Head screw. This design is the most secure and gets in the way the least out of all of them. It fits the 2ah and 3ah batteries no problem and should fit all of them. This one does need supports as it prints with the outside face down so the inset screw needs support, for me tree supports work flawlessly so this was no big deal.

This is a complete redesign but I did use the original as inspiration for the back clip and always want to give credit when it is due. All clips use 2 magnets for each hole as I found i wanted lots of strength, but some people might only desire one. Magnet size is 12x2mm. Super glue is needed to hold magnets in. I used M4x6mm Cap Head screws to mount them.

I print these with lots of walls, nearly solid plastic as they suffer a lot of abuse during use. So far they hold up well.