Building the HMB Endeavour

I decided to use the lockdown to finally get to build a model ship. I have thought about it since I was about 7 (which makes it more than 50 years), and NOW is the time.

During the build I am going to need some bit to help in the process, and I thought that I might as well share them with the world.

These bits are designed to fit the model by OcCre (scale 1:54) and might not fit other models.
In which case, you shall have to adapt them.

I shall add more bits to the list as I need and design them.

1. Work stand - in two parts. will only work until the cladding is fitted.
2. Angle block - to help with getting stuff lined up at an angle.
3. Angle block inside - for the bits that need to be squared
4. Right Angle Support Block - this is specifically to help square the frames to the spine.
5. Barrels - two sizes - butt and tun - On this model there will be an open hatch so you can see what is below deck. I thought some barrels would be nice.

added december 28th.
6) Seaman scrubbing the deck
7) Bucket for the scrubbing seaman

added december 29th.
8) nailer - which is a handle made for a torx-bit with a hole in the tip. A space is ready for a magnet 3xø8 millimeter to be included during the print.