ANYCUBIC Photon Zero to Wash and Cure Station Adapter

ANYCUBIC Wash and Cure Station Adapter for mounting the buildplate
from the ANYCUBIC PHOTON ZERO for Washing models/plate


Engineered By:	Anthony Musgrove
Tested By:		Anthony Musgrove
Contact:		        [email protected]
CAD:			Creo Parametric 3.0
Creation Date:		28/12/2020

Additional Hardware Needed:

1x M6x16mm BOLT  	(Bunnings, a few dollars)
1x M6 NUT		       (Comes with pack of bolts from Bunnings)
(Bunnings Link: https://www.bunnings.com.au/pinnacle-m6-x-16mm-stainless-steel-hex-bolt-and-nut-10-pack_p2320001)

1x M6 FLAT WASHER (12mm OD)
(Bunnings Link: https://www.bunnings.com.au/pinnacle-m6-stainless-steel-flat-washer-12-pack_p0130533)

Print Settings (all_bracket_parts.stl):

* Layer Height:		0.2
* Wall Count:		        3
* Infill:		               15%, Lines
* Material Tested:	        PLA+ (Purple, 3DFillies)
* Printed Temp:		210 degrees C
* Support Material:	        Enable supports build-plate only - support may be used for washer recess (against buildplate) and possibly a little bit on the rounded edges.
* Print Time:		34 minutes (approx) on CTC Replicator Dual

Print Settings (bolt_wheel.stl):

* Layer Height:		0.2
* Wall Count:			3
* Infill:				30%, Gyroid
* Material Tested:		PLA+ (Purple, 3DFillies)
* Printed Temp:		210 degrees C
* Support Material:		Enable supports, build plate only, it will be used for the NUT recess.
* Print Time:			34 minutes (approx) on CTC Replicator Dual


Files:

all_bracket_parts.stl	ALL bracket parts, oriented in their designated print orientation - don't change orientation!
								
bolt_wheel.stl			The wheel/knob to tighten and loosen the bolt.  Oriented in print position - print as it is, with supports.

Assembly:

* Print all_bracket_parts.stl (all three parts, top, bottom and middle)

* Print bolt_wheel.stl with the separate print settings above.

* Ensure no elephant foot on any of the holes - clean up with a deburring tool to ensure correct fitment.
  
* Superglue inside the NUT hole, spray the NUT with Accelerator, and install NUT in place, let
  it fuse well.
  
* Superglue the washer recess on the MIDDLE part, then spray the WASHER with Accelerator, and install
  WASHER in place, let it fuse well.
  
* Prepare the top piece for installation - the centre slot piece should have superglue placed on
  top of it, and then the middle piece slides down onto it, with the washer side UP - the WASHER side MUST
  go TOWARDS the NUT on the BOTTOM piece.
  
* Slide the middle piece down the spine, letting the spine go through the spine hole, all the way down
  until the middle piece is firm up against the alignment slider
  
* Once fused, place enough super glue over the washer, and the plastic piece, ready for the surface with the NUT to
  also slide down the spine - press this firmly together and spray with accelerator.
  
* Superglue inside the bolt-wheel (knob) bolt fitment area.  Spray the top of the bolt with accelerator and install
  the head of the bolt into the bolt-wheel (knob) bolt fitment area.  let it fuse well.