Stock Cam-Lock Lever Assy

These are stock Cam-Lock Lever parts and Rear Clips for the build plate on a CR6-SE.

I also have a set of printable stock Cam-Lock Levers with Pull Tabs, along with ones for adding a Flex Plate. You can find them here along more of my designs - https://www.thingiverse.com/dps_designs/designs

PRINTING NOTES:

Material: ABS
Infill: 50
Speed:50-75
Adhesion: Skirt
Supports: No

PRINTING POSITIONS:

Mounts - Rotate 90 degrees on side w/o supports. Or if your worried about structural strength leave upright w/ supports. Either way should work just fine for this.

Cam-Lock Levers - These could be rotated 90 degrees so they lay on the side of the arm for a little less support needed, but I find that printing straight upright gives just a slightly better result. Plus I had one of test prints fill the dip on the end of the arm with support, which was a pain to get out.

Clips - Rotate 90 degrees so they are on their sides.

HAPPY PRINTING!