Ender 3 Bed Handle - More stability

Hello,

First : Many thanks to LarnOm for the original file, really great job !
I tought that an addition of more stability was a good idea .... because I was a little bit afraid to moove springs and my bed setting when movind it, so here is my humble remix.
Result is veru tight .... no more fear to moove bed srings !

PS : A "washer" (little and thin metal ring, many thanks to Vaderag for correcting me with my poor and bad english ) must be placed between the handle and the adjustment wheel to avoid damaging the handle.

(This is my first post here !! Youhouuuu !!! ^^ )

---

EDIT :
2021-02-18 : PLEASE BE ADVISED : With yellow "flat" springs replacement, you'll need to place a little bit up your Z axe stop sensor !!! (Otherwise your bed will to too high).

2021-02-19 : new version is born !!! No need to worry about springs and Z stop sensor ... All is fine for all kind of springs !
Replace previous version.

2021_02_20 : "V4" New version, flat printable ... just in case ...

---