TBS Tracer MicroTX design #1 (+Crossfire v1 & v2)

Alternative cover for TBS Tracer MicroTX, Crossfire v2, and Crossfire v1.
For Crossfire v1 use TF_017_CRSF_v1.STL

(Nano version here:
https://www.thingiverse.com/thing:4817378)

While using maximum power output during summer the module might get hot and power output will be probably reduced.
This cover should improve cooling.
As the RF module is on the wrong side of the board, it might not be groundbreaking,
but cooling PCB from the other side will remove at least some heat from the RF module.
And it will definitely improve the look of the Tracer/Crossfire module :)

No modification needed and you can put everything back as it was if you don't like it.
(original SMA connector cover can be also used as the holes are in the same place)
If you don't mind removing the Crossfire v2 SMA cap, then I made one that fits with the design. Or just buy extra antenna.
The SMA cap is not necessary on Crossfire and it's there only because of certification.
For Tracer I recommend printing also the SMA cover as the connector is very long and it prevents overtightening (use the original rubber O-ring).

To use the bind button, put plastic/nylon 2mm screw through the hole before attaching the board.
If not, you can use LUA script or TBS agent lite to activate binding.

If you have some comments you can also find me on Joshua Bardwell's Discord server.

(I might do another design later on with a fan, but no promises)